The DeeZee Specialty Series ATV Toolbox # DZM207 does not require support under the tool box to carry cargo. If you wanted to attach the back wall of the toolbox to the side of your car trailer you could easily carry 50-75 lbs of cargo.
You would want to brace the wall of the trailer as well as the install brackets used in the tool box. view full answer...
The Superwinch Winch 2 Go 4000 SR, part # SW1140232, is designed fto operate with power input from the batteries typically found in lawn tractors, ATVs, UTVs or motorcycles.
Naturally, the higher the battery capacity the more running time. According to my contact at Superwinch a jump box would give you enough power for single full-length pull. A fully charged 230-Ah motorcycle battery would do about the same. view full answer...
The best way to extend the wiring would be to get 10 Gauge Blue Primary Wire, part # 10-1-1, to extend the wiring and then use a 12-10 Gauge Butt Connector, part # 05732-2, to connect the wires. And then finally wrap the connection with Electrical Tape.
That should give you the additional 12 inches you would need to connect your Superwinch LT2000 ATV Winch, part # 1120210, to your 2005 Yamaha Wolverine 350 FX.
I attached installation instructions for the # 1120210 below. view full answer...
While I was unable to locate a diagram showing installation of the Replacement Lock Cylinder for UWS Toolboxes w Square Paddle Handles - CH502 # UWSLOCKCH502 I did add a photo that should be helpful.
The accompanying photo is of the Replacement Locking Paddle Handle for UWS Toolboxes # UWSLOCKING and it shows the cylinder when it is in the locked position. So when you install the cylinder you will want to ensure it is in that position so you can lock the handle. view full answer...
Go To Results